|
For 3 set faceplate, it requires
T6 Torx screwdriver
to remove and replace the middle section.
* Click image enlarge viewing |
|
 |
1. Use your fingernail to lift the top of the original
cell phone lens and pull it away from the cell phone.
2. After removing the top section, you will see two
screws which must be removed with T6 scredriver before installing the middle section of
your new faceplate set over the top piece. |
|
 |
3. Simply remove the top section by unsnapping it from
the middle section of new faceplate set. |
|
 |
4. After removing the top section of new faceplate set, install the middle section of new faceplate set over your cell phone
with the T6 screwdriver. |
|
 |
5. Then put the lens
that comes with new faceplate set in place, before installing the top piece. |
|
 |
6. Insert the tab at the bottom of the top piece
into the bottom of the cell phone flip, and use your thumbs to press
along the sides of the lens as you press it into place.
* We recommend contacting your local cell phone store for 3 set faceplates installation.
3 set faceplate |
For 2 set faceplate, simply follow step 1 and 2 changing the top section.
* Click image enlarge viewing |
|
|
1. Use your fingernail to lift the top of the original
cell phone lens and pull it away from the cell phone.
2. After removing the top section, you will see two
screws which must be removed before installing the middle section of
your new faceplate set over the top piece. |
|
 |
2 set faceplate |
